Disassemble and Reassemble a Carburetor

Disassemble and Reassemble a Carburetor

Disassemble

Step 1: Remove top cover to do this remove the screw.

Step 2: Then remove the slide and the jet needle.

Step 3: Turn the carburetor upside down and remove the screws on the float bowl and remove the float bowl.

Step 4: Remove the main jet, emulsion tube, and pilot jet. Once they are removed be sure to check the sizes of the jet with the spec. in the service manual.

Step 5: Before you remove the float measure the float height and write in down to check with the spec. then remove the float and float valve by pulling the pin out.

Step 6: Now screw in the pilot screw an count how many turns it takes and write it down. Then remove the pilot screw.

 Reassemble

Step 1: Screw in the pilot screw all the way then turn the screw out to what the spec. is in the service manual.

Step 2: Install the float an float valve and insert the pin to hold them in place. Then measure the float height to make sure its still set to spec.

Step 3: Install the emulsion tube, main jet, and pilot jet.

Step 4: Install the float bowl an tighten the screw. Be sure to not over tighten

Step 5: Reinstall the slide and the jet needle

Step 6: Reinstall the top cover and tighten the screws. Be sure to not over tighten.